Profile Solutions - Home
Leak Detection Automation Technology – Worlds Fastest Single Head Leak Tester
 
 

Test Rates

All the test rates in the Table Link Below are based on using holes made using the 0.17mm (7 thou) wires obtained from Nordson ( normally used for cleaning their glue gun nozzles).

For more information in obtaining these wires please go to our DOWNLOADS PAGE or click on the REAL TESTING DOWNLOAD WHICH HAS PART NUMBERS FOR THESE WIRE AND PIN VICE to hold them.

The test rate of a container is governed by the following factors:

Volume. Generally our tester is not affected by volume as much as standard designs on the market. Buy the physics of the universe dictate that the pressure decay through a hole in a bigger bottle just takes longer.
Shape. 2 bottle of the same bottle but different shape can have very different test times.
Rigidity. A rigid bottle does not creep as much when tested and generally, the more rigid the bottle the quicker the test time will be.
Stability. If a bottle travels on the conveyor poorly and sways when the conveyor starts and stops, the conveyor has to run slower with a long acceleration/deceleration time. This costs precious testing time.
Environment. In a temperature controlled production area the temperature and humidity are controlled a tighter tolerance can bet set, than in a tropical or sub tropical climate where the day/night temperature variation can be 20-30 degrees centigrade. The above mentioned video was done in summer on a hot day with a lot of temperature variation in a non-insulated shed.

How small a hole can we find?

The answer to this is how much test time do we have available.

On the 1 litre oil bottle shown in the table on the high speed machine the test time is around 0.45-0.5 seconds, with a pressure drop of around 0.15 Kpa, by 2 seconds the pressure drop is > 0.4 Kpa.

So a hole smaller than 0.05 mm would take around 1.5-2 seconds to create a pressure drop of around 0.1-0.15 kpa which we can easily and consistently check with the typical variation in bottle production.

Thus if you have the time holes smaller than 0.05 mm can be found. In fact given time we have extrapolated that holes down to > 0.02 mm can be found.

Go to Test Rates Table – Click Here